Sumitomo - Полный каталог инструмента - 2016 EN

                                                                      для заказа - sumitomo@sumitomo-tools.ru

              Non-Ferrous MetalNonSM-Fteeetarerllolus                               Turning Insert Selection Guide

Insert                                                                         Chipbreakers
   Selection
              Positive Type
                                                                               NAG                                          mm                                  New
                                                  NAG                                                                       2,0                                 NGD
                                                  Feed Rate (mm/rev)Depth of Cut (mm)                    Depth of Cut (mm)
                                                                                                                            1,5                                 New
                                                                                                                                                      NGD       NLD

                                                                                                                            1,0

                                                                                                                            0,5
                                                                                                                                                       NLD

                                                                                                                               0 0,1 0,2 0,3 0,4
                                                                                                                                            Feed Rate (mm/rev)

                                                                                    Grades

                                 Cutting Speed (m/min)                         SUMIDIA

                                                                            DA1000

                                                                                                                            Carbide Grade

                                                                                                                              H1

                                                        Finishing                                                           Roughing
                                                                                                                            Interrupted Cutting
                                                        Continuous Cutting              General Cutting

                                 Recommended Cutting Conditions                                                                                      (Min. - Optimum - Max.)

              Cutting            Category                              Grades       Depth of Cut (mm)                       Cutting Conditions    Cutting Speed (m/min)
              Process
                                                                      DA1000         0,1-0,5-3,0                              Feed Rate (mm/rev)        ~ 2000
                 Continuous      SUMIDIA                              DA2200         0,1-0,5-3,0                                                        ~ 2000
                    Cutting      Carbide                              DA150          0,1-0,5-3,0                             0,05-0,10-0,20             ~ 2000
                                                                                     0,3-1,0-5,0                             0,05-0,10-0,20             ~ 1000
              General Turning                                            H1                                                  0,05-0,10-0,20
                 Interrupted
                    Cutting                                                                                                    0,1-0,20-0,5

A28                                                                                www.sumitomo-tools.ru
                                                                      для заказа - sumitomo@sumitomo-tools.ru