Sumitomo - Полный каталог инструмента - 2016 EN
SteelSteel для заказа - sumitomo@sumitomo-tools.ru
Turning Insert Selection Guide
Insert Main Chipbreakers
Selection
Negative Type Positive Type
6 NMU 3 NMU
NMU
Depth of Cut (mm) NME NME Depth of Cut (mm) NSU NMU NSU
4 NGE 2 NLU
(Crater- and Wear-Resistant)
2 NGU NGU NLB New
NGE (Sharper Edge) 1 NLU
NSU NSU NLB
NSE
NSE New
NFB
0 0 NFB
0,2 0,4
0,6 0,2 0,4
Feed Rate (mm/rev) Feed Rate (mm/rev)
Sub-Chipbreakers
Negative Type Chipbreakers for Strong Edge Chipbreakers
High-Efficiency Machining
6
Depth of Cut (mm) 6 Depth of Cut (mm) NMX
NME
4
4 NUX
NGE 2
2
NSE
0 0,2 0,4 0,6 0,8 0 0,2 0,4 0,6
Feed Rate (mm/rev) Feed Rate (mm/rev)
Wiper Inserts
Chipbreakers for Heavy Cutting
NGU-W
Chipbreakers for Small Depths 6 NSE-W 15
3 NLU-W
0,3 0,6 0,9 NHW NHF
Depth of Cut (mm) Depth of Cut (mm) Depth of Cut (mm)
2 4 Feed Rate (mm/rev) 10
NLU 2
0 5 NHU
1 NMP NHP
NFA 0 0,4 0,8 1,2 1,6
0 0,2 0,4 0,6 Feed Rate (mm/rev)
Feed Rate (mm/rev)
l Fine Finishing to Finishing Grades
l Finishing to Rough Cutting
Cutting Speed (vc) New New
Cutting Speed (vc)
T1000A
Finishing Roughing Finishing Roughing
Continuous Cutting Interrupted Cutting
General Cutting Interrupted Cutting Continuous Cutting General Cutting
A4 www.sumitomo-tools.ru
для заказа - sumitomo@sumitomo-tools.ru