Sumitomo - Полный каталог инструмента - 2016 EN
для заказа - sumitomo@sumitomo-tools.ru
Other DN_ _ Type neg. Inserts DIAMONDTYPE
D INSERTS FORTURNING
55° Diamond Type 0° Relief Dimensions (mm) P Steel
With Insert Hole M Stainless Steel
DDNN_M_G l d (IC) s d1 K Cast Iron
a D13, D19 a E9 N Non-Ferrous Metals
1504-- 15,5 12,7 4,76 5,16 S Super Alloy
H Hardened Steel
1506-- 15,5 12,7 6,35 5,16
DNMA / DNMX Carbide Cermet Carbide
Coated ZX-Coated Uncoated
M PM K K S MS PM
P P KSN
Flat Inserts and One Side Handed Inserts AC805P
AC810P
& M-Class Double Sided Bumpy Chipbreaker AC820P Neg.
AC830P Inserts
AC2000
AC3000
AC6030M
AC6040M
AC610M
AC630M
AC405K
AC415K
AC420K
AC900G
AC510U
AC520U
AC530U
T1500Z
T2000Z
T3000Z
T1000A
T1500A
G10E
EH510
EH520
H1
Application Shape ISO Cat. No. r
Roughing DNMA 150608 0,8 l l l
DNMA 150612 1,2 l l l
DNMX 150608 L
0,8 l s
DNMX 150608 R
0,8 l
DNMX 150404 NSE-W 0,4 m m
DNMX 150408 NSE-W 0,8 m m
DNMX 150604 NSE-W
DNMX 150608 NSE-W
Finishing NSE-W DNMX 150612 NSE-W 0,4 l l
0,8 l l
Depth of cut (mm) 1,2 l l
”Wiper” W type
Feed rate (mm/rev) Wiper insert (Note) The cutting point position of the SDW type does not r Compensation (mm)
SDW type follow the ISO standard. X (Diam. ch ange) Z
Wenn using on a boring holder with a 93° approach angle,
Normal there is a need to revise the cutting point position (refer to 0,4 -0,14 ( : -0,28) -0,02
insert right table) relative to using standard inserts.
0,8 -0,14 ( : -0,28) -0,02
1,2 -0,1 ( : -0,2 ) -0,03
l = Euro stock www.sumitomo-tools.ru C25
= Stock item in Japan для заказа - sumitomo@sumitomo-tools.ru
s = To be replaced b new item